The Reports defined with version 3 of Swisslog did not print exactly as defined in the setup. Actually the print was smaller as defined in the Setup Dialog. So for a Label with a height of 37 mm you had to specify 1,52 Inch. But this is actually 38,6mm ( 1Inch = 25.4 mm). In version 4 this was corrected with the result, that the printout was to large because the it was now exactly the size as specified.
For a long time, I did not find out what happened. So I reverted back to the V3 logic in Version 4.04. But this was not the good solution either. Now I added an option which allows to print V3 reports with the V3 logic and new reports with the correct size.
I added a Switch in the Setup Dialog of the Report Generator to indicate if
the V3 Logic should be used for Printing.
This switch is automatically set, when you load a Report which has the V3
Format.
So if your report does not scale correctly and it was created with an earlier version of Swisslog, either correct the sizes or check Version 3 compatible.
Proceed as follows:
